Subject:
|
version of firmware
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 16 Jun 2003 16:38:31 GMT
|
Original-From:
|
Richard Diaz <richdiaz99@yahoo.com>
|
Viewed:
|
815 times
|
| |
|
|
Where can i see the version (1.5 or 2.0) of the
firmware that is loaded into an RCX?
thanks,
Rich
__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com
|
|
Message has 1 Reply:
 | | gear pulley/release system
|
| I have looked all over the forums and archives and still have not found quite what I am looking for. A cocking mechanisim for a cannon. I need a 1x16 beam (the 'bolt', held by rubber bands) to be pulled back and released down an 2x16 chamber pushing (...) (21 years ago, 18-Jun-03, to lugnet.robotics)
|
Message is in Reply To:
| | Re: maze solving algorithm
|
| Thanks for the reply, but this message was meant for Scott Davis regarding the configuration of his particular robot. Timothy Hello Timothy, hello Scott, and hello to all the others off course, i know. Those thougts i mentioned, are general (...) (21 years ago, 14-Jun-03, to lugnet.robotics)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
