To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 20012
    Re: Received my RIS 2.0 - the two motors run at different speed! :-((( —Steve Baker
   (...) Yes - they've recently changed the design slightly - you should check the mailing list archives - there has been a lot of discussion about this. (...) Motors don't all run at the same speed - that's a given - and you have to design your robot (...) (22 years ago, 11-Jan-03, to lugnet.robotics)
   
        Re: Received my RIS 2.0 - the two motors run at different speed! :-((( —Stéphane Simard
   (...) It's definitely higher than 10%. When my rover is running far enough, it's turning right enough to form a triangle whose side ratio is about 1 length for every 6 traveled, so it's somewhere between 15% and 20% difference. I will call Lego (...) (22 years ago, 11-Jan-03, to lugnet.robotics)
   
        Re: Received my RIS 2.0 - the two motors run at different speed! :-((( —Steve Baker
   (...) Is it? Did you do the math or are your just guessing? There isn't enough information to figure the math from what you've told us... It depends on how wide your robot is and what units that triangle is in (feet? meters? miles?). But let's make (...) (22 years ago, 11-Jan-03, to lugnet.robotics)
   
        Re: Received my RIS 2.0 - the two motors run at different speed! :-((( —Stéphane Simard
   First of all, let me say that I very much appreciate your deep insight and your math formulas, which I have forgotten years ago. :) After further testing and measuring, I found that the difference is much larger - it actually deviates a good one (...) (22 years ago, 11-Jan-03, to lugnet.robotics)
   
        Re: Received my RIS 2.0 - the two motors run at different speed! :-((( —Steve Baker
   (...) OK - so...doing the math carefully and explaining how I did it... 1m ______ E | *\ | * \ | * \ 3m | * \ | * \ |* \ |___...___\C S P * == The curved path taken by the robot. S == The start point of the robot. E == The end point of the robot C (...) (22 years ago, 11-Jan-03, to lugnet.robotics)
   
        Re: Received my RIS 2.0 - the two motors run at different speed! :-((( —Stéphane Simard
   (...) Once again, thanks for making all the calculations for me... Anyway, at the very least, I'll test all four of my other regular gear motors in a mindstorms robot. If I'm lucky to find a pair that are of equal speed, I'll use them in my (...) (22 years ago, 12-Jan-03, to lugnet.robotics)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR