 | | Re: legOS - Does it work for you?
|
|
I too have a similar problem. Using cygwin-b20 on a win98 machine to build the light-sensor demo under legOS 0.1.4 I downloaded the cross compiler from (URL) ( Gavin Smyth posted this address a few days ago.) With the light-sensor demo, the 12th (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
|
| |
 | | Re: legOS - Does it work for you?
|
|
(...) Not necessarily - it may be that the replacement happens to put things were some memory corruption doesn't hit them... Cheers, Ben. (28 years ago, 31-Dec-98, to lugnet.robotics)
|
| |
 | | Re: RCX 2.0 -- ideas.
|
|
The Version @.0 should have a way to allow multiply RCX's to used. That way one RCX could be used for just the motor routines, one to handle sensors, one to do number chrunching, and etc. John A. Donaldson (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
|
| |
 | | Re: sensor input mux calculations
|
|
I've thought about this, but I've come up empty. If you could get between the input line and the 10K pull-up resistor, it would be easy. You could then wire the CdS cells on either side, with a 10K resistor from one cell to ground. Then when the (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Glueing blocks
|
|
I've successfully created mating surfaces by using a gel superglue. To create the mating surface, create a flat surface (if one doesn't exist) with epoxy. Then spread the gel glue on the suface, put down a piece of celophane wrap. Then press a lego (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
|