To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 1971 (+5)
  Re: Antenna Bumpers/Insects
 
(...) Yes, I've seen just this behaviour. Work-around -- (i) use the purple corrugated pipes as antenna, with just a short axle in the end; and (ii) instead of mounting the two antennae on one pivot (so that they're fixed in relation to each other) (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
 
  Re: Bumper Ideas Needed
 
(...) I've had a good deal of success with multiple antennae hanging from horizontal axes which when actuated lift a piston vertically to connect with a sensor mounted above it, thus: # <- touch sensor ^ | <- piston | === o--- ---o <-- antenna pivot (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
 
  Re: legOS - Does it work for you?
 
(...) I tried that with the same results. At that point, I added some debug messages to the malloc and free routines. Using the demo light-sensor program I wrote down the addresses returned by malloc. There are only two calls per execi, the (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
 
  Re: Bumper Ideas Needed
 
Hey Simon: I got it! If you mount the touch sensor centrally on your craft and you make a jig using the springy arms (corrugated stuff) that goes totally around the robot and ... I'll put a picture up on my website ASAP You have to monitor a (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
 
  Re: Slope Parameter in SetSensorMode
 
(...) Just a little plea. You've set the font on your page to 'Arial', which is a Microsoft only font. So for those of us who don't use Microsoft the page is almost unreadable. Would you mind either not setting a font at all or setting it to (...) (28 years ago, 31-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR