Subject:
|
Re: Voltage Sensor
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 17 Sep 2002 21:37:17 GMT
|
Viewed:
|
916 times
|
| |
|
|
Hello again,
if you have difficulties making sense out of my previous posting, try
viewing it with a fixed-width font. Otherwise all fomulas will ook scrambled.
In the Web interface, "view raw message" is likely to work for that purpose,
but of course everything depends on your specific software (browser,
newsreader) configuration ...
Greetings
Horst
|
|
Message has 1 Reply:
 | | Re: Voltage Sensor
|
| (...) Wow, thanks Horst. Your last email had 'weekend project' written all over it. Everything was quite straight forward (including the equations) and extremely well presented. I'll keep you posted on how it goes, and if I get stuck, no doubt you (...) (22 years ago, 18-Sep-02, to lugnet.robotics)
|
Message is in Reply To:
| | Re: Voltage Sensor
|
| Hello Tom, (...) Yes. You need a low impedance output driving 0..5V into the RCX, thus overriding its internal pullup. (...) Actually, I should have written "resolution" instead of "accuracy". The 10..15V range spans 5V with 256 steps, giving you a (...) (22 years ago, 17-Sep-02, to lugnet.robotics)
|
11 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
