 | | Re: sensor connectors
|
|
OOoopsss... LegoMajik@aol.com not LegoCork, that's Mindstorms name. Dohh!!! (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | RCX Serial
|
|
I'm embarassed to post with such a trivial discovery, but in the hopes of saving somebody a little time: You can get the serial port to transmit under legOS by doing *((char *)0xffd0) = 0x09; // TCR *((char *)0xffd1) = 0x13; // TCSR *((char (...) (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | R/C Servo to Legos
|
|
Does anyone have a solution for coupling the output of an R/C servo to something like a Lego axel? Thanks. (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | Re: R/C Servo to Legos
|
|
You could glue a lego gear onto the servo horn and axles into that. (...) (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | Re: R/C Servo to Legos
|
|
The srevo parts are Nylon, hard to glue on to that. I dont think gooping on epoxy would hold vary well, might be wrong. (...) (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | Re: R/C Servo to Legos
|
|
John Kittelsrud writes: > Does anyone have a solution for coupling the output of an R/C servo > to something like a Lego axel? I did it using an axle stopper glued on with hot-melt glue. Worked fine until I would over-torque it. (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | lego train and motors
|
|
Hi all. I received a cargo train for Christmas and was experimenting with the motors and speed control unit. I would like to incorporate the tracks and railway motor into some RCX projects in the near future. When I hook a regular lego motor (the (...) (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | Re: R/C Servo to Legos
|
|
(...) something like a (...) The usual way the RC community does it is to use a cover from a auto tire valve stem, fill it with epoxy and push it over the splines of the output shaft. Be careful that no epoxy runs down into the bearing of shaft :-). (...) (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | sensor details
|
|
Do the sensors read voltage or measure resistance? or both? chris (28 years ago, 27-Dec-98, to lugnet.robotics)
|
| |
 | | Sensor ideas
|
|
Looking at some of the ideas for multiplexing touch sensors gave me a couple of ideas - I may not get around to constructing these anytime soon so if someone wants to run with them I'd sure like to hear how you did. Idea #1 - Whisker sensors using (...) (28 years ago, 26-Dec-98, to lugnet.robotics)
|