Subject:
|
R/C Servo to Legos
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 27 Dec 1998 07:31:37 GMT
|
Original-From:
|
John Kittelsrud <johnkit@primenetSPAMCAKE.com>
|
Viewed:
|
1233 times
|
| |
|
|
Does anyone have a solution for coupling the output of an R/C servo to something like a
Lego axel?
Thanks.
|
|
Message has 3 Replies:
 | | Re: R/C Servo to Legos
|
| John Kittelsrud writes: > Does anyone have a solution for coupling the output of an R/C servo > to something like a Lego axel? I did it using an axle stopper glued on with hot-melt glue. Worked fine until I would over-torque it. (26 years ago, 27-Dec-98, to lugnet.robotics)
| | | Re: R/C Servo to Legos
|
| (...) something like a (...) The usual way the RC community does it is to use a cover from a auto tire valve stem, fill it with epoxy and push it over the splines of the output shaft. Be careful that no epoxy runs down into the bearing of shaft :-). (...) (26 years ago, 27-Dec-98, to lugnet.robotics)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
