To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 15822
15821  |  15823
Subject: 
Re: Power inlet to RCX 1.5?
Newsgroups: 
lugnet.robotics
Date: 
Fri, 27 Jul 2001 00:41:38 GMT
Viewed: 
1337 times
  
In lugnet.robotics, Darren Chapman writes:

"rhendrix" <rmhendrix@hotmail.com> wrote in message
news:GH06Ju.L9J@lugnet.com...
<snip>
So, does anybody have any tips on creating a dummy powerpack the shape of • a
1.5 V battery?

What about a wooden dowel with a screw in the end to hold the wire?

I haven't seen the earlier posts in this thread but I assume we are talking
about a way of getting an AC adaptor to drive an RCX from 1.5 without
hacking the hardware.

If so then I have been pondering this as well and was thinking of using some
of the dummy AA batteries epoxied together. I don't know if you are UK based
or not but if so then maplin seem to list something suitable
(www.maplin.co.uk - search for code YX92A)

Let me know if you get anywhere with this!

Darren

That's right, Darren,
but I'm not from Britain, so I'll look at the product for ideas. Is it
necessary to fill the entire battery bay, or will one AA suffice to provide
the power needed? Also, I'm not only pondering the technicalities of
building dummy AAs, but also the actual voltage I have to supply, for 9.6
Volts didn't yield any results. Does anybody have any clues on this issue?

Grtz.,
Remko



Message has 1 Reply:
  RE: Power inlet to RCX 1.5?
 
(...) There are 12 contact pads in the battery bay. One is the + lead to the RCX, one is the - lead to the RCX, and the other 10 are used to connect the batteries in series. You need to supply power to the two contact pads that connect to the RCX (...) (23 years ago, 27-Jul-01, to lugnet.robotics)

Message is in Reply To:
  Re: Power inlet to RCX 1.5?
 
"rhendrix" <rmhendrix@hotmail.com> wrote in message news:GH06Ju.L9J@lugnet.com... (...) a (...) I haven't seen the earlier posts in this thread but I assume we are talking about a way of getting an AC adaptor to drive an RCX from 1.5 without (...) (23 years ago, 25-Jul-01, to lugnet.robotics)

19 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    
Active threads in Robotics

 
Contact Recovery Nerd for Speedy USDT / BTC Recovery
19 hours ago
Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR