 | | Re: Black friction peg size
|
|
The first time I noticed the less thick black pegs was in the 8448 Superstreet sensation and in the other technic sets from the same year (8444, 8445, 8446). It seems to me that there are 4 different kinds of black pegs that came out over time, but (...) (24 years ago, 26-Feb-01, to lugnet.robotics)
|
| |
| | Re: NQC 2.31b 1 and the RCXcc
|
|
----- Original Message ----- From: "Miles Gentry" To: <lugnet.robotics@lugnet.com> Subject: Re: DDK - What use are they / lower prices seen> To go to an even higher level, after you get the new NQC, then get RCX2 (...) On the download page it says: (...) (24 years ago, 26-Feb-01, to lugnet.robotics)
|
| |
| | Black friction peg size
|
|
While I was makeing a simply fixture to mount black friction pegs in a lathe, I discovered that they come in two different wall thicknesses! I had never seen a posting about this and I had never noticed it before, but it accounts for why some things (...) (24 years ago, 26-Feb-01, to lugnet.robotics)
|
| |
| | Wall transformer for RCX
|
|
I have seen a number of post asking the same question, What to use for external power for the RCX (ver 1.0) I have been using RadioShack; cat # 273 1631 - 9v 800mA AC This transformer has the correct size jack. The output voltage is adjustable. I (...) (24 years ago, 26-Feb-01, to lugnet.robotics)
|
| |
| | How big is too big?
|
|
I have a NQC program that is not working properly. However, when ever I complie and run a smaller section of the code it works fine. The basics of the code is the following: 1. wait until you get a valid message from RCX1 (code is for RCX2) 2. go (...) (24 years ago, 26-Feb-01, to lugnet.robotics)
|
