 | | Re: Programming languages
|
|
I can only speak from experience about programming languages that use the standard firmware, since that's all I've used. *Spirit.OCX (I've used VB and J++): The worst way to program in the standard firmware. non-intuitive syntax (even if you replace (...) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | Re: RIS 2.0 status
|
|
But how can that be? It says on their RCX 2 SDK page that all these people can choose to get the RIS 2.0, to be released in Spring 2001. (...) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | RE: Programming languages
|
|
What an interesting question, and I hope it solicits a comprehensive review from someone who has the breadth to understand and use them all. I use nqc all the time because it is SO easy. - thanks Dave! But, I would like the freedom offered by a (...) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | Re: Mac IR tower
|
|
Greg, You can get the correct cable from Pitsco-LEGO/Dacta or make your own without too much difficulty. Regards, Lon (...) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | Mac IR tower
|
|
What would be the best way to hook up the IR tower to a non-USB mac? Thank You, Greg Ericksen (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | Re: RIS 2.0 status
|
|
I don't think so, I called LEGO and asked them some weeks ago, they told me it woulden't be available until fall!! Christian (...) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | RIS 2.0 status
|
|
Can anyone comment here on the status of the so-called 2.0 system. Can they be purchased yet? If so, where? TIA Harley Myler (URL) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | RE: IR tower problems
|
|
(...) One technique that is forgotten in the days iof surface mount is to use a sacrificial connector. Back in the olden days, when we updated a BIOS by changing the actual chip (no FLASH then) we would often put the chip in a second socket, or put (...) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | Re: IR tower problems
|
|
A lot of computer connectors are designed for "installation" connection, not repeated connect and disconnect. I would suggest you install a short male to female "pigtail" cable to relieve wear and tear on your already failing connector. Use of such (...) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
| |
| | Re: IR tower problems
|
|
(...) If you open up the computer, you should be able to push them back into place from the back of the connector. However, once they get displaced like that, it'll happen more and more often. In the end, you'll have to push the tower cable into the (...) (24 years ago, 14-Feb-01, to lugnet.robotics)
|
