 | | Real Basic or applescript tools.
|
|
Hello, I have a project were I want to send messages to my RCXs' I would like to use applescript or real basic as I want to be able to have the RCX to be controllable from other non Lego related apps. I did some digging and there is an Applescript (...) (25 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
| | Re: Ball-less mice (was :Re: FW: Another DIY sensor)
|
|
Oh. I sort of figured that you took the stuff out of the mouse (i just went back and read all the messages ;), it just that I have an optical mouse and i wouldn't want to take it apart. if the rcx could read the outputs from the mouse directly, then (...) (25 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
| | Re: Ball-less mice (was :Re: FW: Another DIY sensor)
|
|
Jason wrote: >Doing a little research, I found out that, when >used with ps/2, mice are supplied 5 volts dc and have two data outputs, for a total >of 4 wires. I'm not sure how much power the rcx supplies, but optical mice should >be able to work (...) (25 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
| | Re: Ball-less mice (was :Re: FW: Another DIY sensor)
|
|
I just got a usb or ps/2 optical mouse (with a wheel!) for $20 at compusa. I'm not sure who is trying to get an optical mouse to work with the Rcx, but i'd like any information on it that they have. Doing a little research, I found out that, when (...) (25 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
| | Recipricating motion problems
|
|
I have two 24 tooth gears. The lower gear is one hole down, six holes over from the upper gear. Like so (the @ are where the center of the gears are): @ @***** ^1 2^ I need to make it so that by turning gear 1 continusaly, in only one direction, (...) (25 years ago, 30-Nov-00, to lugnet.robotics)
|
