 | | Re: Motorized VC cam focusing
|
|
(...) Well i havent tried anything myself but i think the most effective way would be to use a tire in contact with the lens. You've probably tried that already, but it was the first thing that came to mind. hope it helps. (25 years ago, 4-Nov-00, to lugnet.robotics)
|
| |
| | Motorized VC cam focusing
|
|
Hi, I wonder if anybody has succeeded in building a motorized focus controller for the Vision Command cam. So far I have tried several ideas but none was very effective. I am looking for better ideas. Jan (25 years ago, 4-Nov-00, to lugnet.robotics)
|
| |
| | AI in RCX
|
|
I want to program AI into RCX that can avoid objects by the readings of 3 three ultra-sonic sensors. I am supposed to use Neural Network. But I difficult as the programming is limited by the RCX (even RCX 2.0 is used) Would you be kind enough to (...) (25 years ago, 4-Nov-00, to lugnet.robotics)
|
| |
| | Re: How2 'count' in NQC
|
|
In lugnet.robotics, Jerry Kalpin writes: [SNIP] (...) There is an EDGE mode available through the firmware that only counts transitions between pressed and non-pressed (actually some raw threshold value if I remember correctly) states. This sensor (...) (25 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
| | Re: How2 'count' in NQC
|
|
I have noticed this ongoing thread about the difficulties of debouncing and counting switch closures, and I must say that it is a very real problem anywhere electromechanical switches are interfaced to electronics which is orders of magnitude (...) (25 years ago, 3-Nov-00, to lugnet.robotics)
|
