Subject:
|
IR and Com Ports and such
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 1 Jun 2000 20:50:50 GMT
|
Viewed:
|
648 times
|
| |
|
|
Hi, there.
This is more of a BIOS question, but I thought you folks might have some
ideas...
I just bought Mindstorms RIS and have run into a snag. I had to install a new 9-
pin serial port to start with, which I did, and the computer assigned the 9-pin
thingy an IRQ that doesn't match what the RIS infrared device wants. Apart from
going into the BIOS or DOS and reassigning everything to different ports and
IRQs and such, is there any way the infrared device can be made to use something
other than the recommended Com Ports and IRQs? (You can tell I'm clueless about
infrared devices.)
Any suggestions you may have will be appreciated.
Barbara
|
|
Message has 1 Reply:
 | | Re: IR and Com Ports and such
|
| Barbara Pamp schreef: (...) The Mindstorms IR tower doesn't have it's own IO address or IRQ. It uses the COM ports address or IRQ. Now the port you added... is it Plug'n'Play? If NOT -> There should be a few jumpers on the card. If you want it to be (...) (24 years ago, 1-Jun-00, to lugnet.robotics)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
