To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *851 (+5)
  encoders routine
 
I am having difficulty using the Encoders.c routine for the handyboard. I have written some code that continually reads the encoder (port 0) and writes it to the LCD, then waits 30 [ms] so that the value is readable. I called this code testsens.c (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
 
  board error
 
hi, i've run into some problems with my board. When i switch on the reset button the motor leds(red) 0 and 1 are on. The green led (power ready indicator) is also ON. But the Interactive C version etc etc are not printed on the LCD including the (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
 
  Radioshack ultrasonic tape measure
 
I while ago I remember reading a web page where someone described using a radio shack tapeless tape measure for its ultrasonic transducer and reciever. They described how to modifiy it and what was what for using it with a micro controller. After (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
 
  some [Q]'s
 
Hi. I have a few questions related to the handyboard: 1) In the "How to connect DC motors to HB" paper, it says to use .1 inch male headers to connect the wire leads to. Can anyone give me a less general specification for these male headers? 2) Is (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
 
  Re: board error
 
Hi Sriram, Have you tried reloading the pcode_hb.s19 file into the Handy Board? Perhaps it has been corrupted. - Prabal (...) (30 years ago, 22-Oct-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR