Subject:
|
Radioshack ultrasonic tape measure
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 21 Oct 1996 22:05:27 GMT
|
Original-From:
|
Garth Webb <g-webb@students.uiuc{AvoidSpam}.edu>
|
Viewed:
|
1538 times
|
| |
| |
I while ago I remember reading a web page where someone described
using a radio shack tapeless tape measure for its ultrasonic transducer and
reciever. They described how to modifiy it and what was what for using it
with a micro controller.
After some fruitless web searching I was wondering if anyone has
seen this and could send me the address. These tape measures are about $30
which is much less than the $50 for a polaroid; this is important to me.
Thanks
---
Garth Webb
g-webb@uiuc.edu
|
|
Message has 1 Reply: | | some [Q]'s
|
| Hi. I have a few questions related to the handyboard: 1) In the "How to connect DC motors to HB" paper, it says to use .1 inch male headers to connect the wire leads to. Can anyone give me a less general specification for these male headers? 2) Is (...) (28 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|