 | | re:color sensors
|
|
Hi, has anyone tried using color sensors with the handyboard?? (30 years ago, 20-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | want to buy a handyboard
|
|
Hi, I need a handyboard for a project in a controls course at the University of Utah but I can't really afford one. Furthermore, I don't have the time or wisdom required to assemble one on my own. Is there anyway to get one used? Or, if I were to (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | Re: color sensors
|
|
(...) See the latest Nuts & Volts. There is a great article about a "Pick up the Tennis balls and put them in a pen" contest. As a sideline, they talked about one chase robot being tuned to just chase orange. Not a lot of details, but there are (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | Re: color sensors
|
|
(...) What Is that Nuts & Volts ?? Thanks Oriol (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | Unsubscribe
|
|
Please unsubscribe me from the handyboard mailing list. Email: J.T.Hillebrand@lr.tudelft.nl Jasper Hillebrand (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | encoders routine
|
|
I am having difficulty using the Encoders.c routine for the handyboard. I have written some code that continually reads the encoder (port 0) and writes it to the LCD, then waits 30 [ms] so that the value is readable. I called this code testsens.c (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | board error
|
|
hi, i've run into some problems with my board. When i switch on the reset button the motor leds(red) 0 and 1 are on. The green led (power ready indicator) is also ON. But the Interactive C version etc etc are not printed on the LCD including the (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | Radioshack ultrasonic tape measure
|
|
I while ago I remember reading a web page where someone described using a radio shack tapeless tape measure for its ultrasonic transducer and reciever. They described how to modifiy it and what was what for using it with a micro controller. After (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | some [Q]'s
|
|
Hi. I have a few questions related to the handyboard: 1) In the "How to connect DC motors to HB" paper, it says to use .1 inch male headers to connect the wire leads to. Can anyone give me a less general specification for these male headers? 2) Is (...) (30 years ago, 21-Oct-96, to lugnet.robotics.handyboard)
|
| |
 | | Re: board error
|
|
Hi Sriram, Have you tried reloading the pcode_hb.s19 file into the Handy Board? Perhaps it has been corrupted. - Prabal (...) (30 years ago, 22-Oct-96, to lugnet.robotics.handyboard)
|