 | | batteries port
|
| dear readers, i am current using power supply of around 15 to 20 volts to supply to my HB. i remove the 9.6 batteries supply cause it does not have the strength to drive my 30 v dc motor. will it affect the board? jass (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| | |  | | Re: Sensor monitoring
|
| Mark Dollar wrote in message ... (...) There is no passive way to multiplex analog values into an analog value. With extra electronics you could threshold each CdS sensors level to a binary signal and then convert them to back to analog. For an (...) (28 years ago, 23-Jan-99, to lugnet.robotics)
| | |  | | Re: DATALOG and C
|
| (...) Worse than that, the IR tower will not receive a message unless it is currently powered up. Since the IR tower automatically powers down a few seconds after transmitting data, you will not be able to receive data unless the C program (...) (28 years ago, 23-Jan-99, to lugnet.robotics)
| | |  | | Re: Stack Overflow
|
| Hi there, In my humble opinion, I suspect that the problem is with Interactive C.. Try a newer or older version. What version are you using, by the way ? To quote Levine et al, "lex & yacc", 2nd Ed, O'Rielly & Assoc page 259: "yacc stack overflow (...) (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| | |  | | Memory Map with Expansion board
|
| Hi Folks, I was just reading the FAQ and encountered the part about the memory map. Does anyone know how the expansion board maps as it is not included in the memory map in the FAQ? Thanks, Chris Prosser (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| |