To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *8086 (+5)
  Light outputs on RCX
 
Has anyone ran lights from the RCX outputs? I need something brighter than an LED, any ideas? Thanks, Bryan Bible --- __o --- __o Tandem Computers --- _ \<,_ --- _ \<,_ Austin Texas --- (*) / (*) --- (*) / (*) bryan.bible@compaq.com -- Did you check (...) (28 years ago, 18-Jan-99, to lugnet.robotics)
 
  Re: Light outputs on RCX
 
(...) I took apart a laser pointer. I put the laser module into a mutilated brick. I added a diode, an LM-317, appropriate resistors and a .1uF capacitor to make a 3 volt power supply. The diode makes it so the laser is on for motor forward, off for (...) (28 years ago, 18-Jan-99, to lugnet.robotics)
 
  Re: Light outputs on RCX
 
Paul Haas writes: > On Mon, 18 Jan 1999, Bible, Bryan wrote: > > > Has anyone ran lights from the RCX outputs? I need something brighter than > > an LED, any ideas? > > I took apart a laser pointer. I put the laser module into a mutilated > brick. I (...) (28 years ago, 18-Jan-99, to lugnet.robotics)
 
  Re: digital and analog port on HD
 
(...) A digital port can't have the capability of an analog port, since it has only one bit of information with which to work. (A 256-value analog port has eight bits.) You could perhaps hook an analog sensor up to a digital port using some sort of (...) (28 years ago, 18-Jan-99, to lugnet.robotics.handyboard)
 
  Re: digital and analog port on HD
 
(...) Just thought I would add that it *is* possible (if a bit slow) to read an analog signal w/ a digital port by timing the decay of the signal thru a RC circuit...not a particularly precise method, either. < Watching for the Fedex guy bringing my (...) (28 years ago, 18-Jan-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR