Subject:
|
Re: Light outputs on RCX
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 18 Jan 1999 16:33:14 GMT
|
Original-From:
|
Russell Nelson <nelson@crynwr^saynotospam^.com>
|
Viewed:
|
1174 times
|
| |
|
|
Paul Haas writes:
> On Mon, 18 Jan 1999, Bible, Bryan wrote:
>
> > Has anyone ran lights from the RCX outputs? I need something brighter than
> > an LED, any ideas?
>
> I took apart a laser pointer. I put the laser module into a mutilated
> brick. I added a diode, an LM-317, appropriate resistors and a .1uF
> capacitor to make a 3 volt power supply. The diode makes it so the laser
> is on for motor forward, off for reverse. Thus if I make another, they
> can share a port.
>
> I haven't had a chance to use it much yet.
Minifig Death Ray! Wait until the Ninjas find out about this!
--
-russ nelson <rn-sig@crynwr.com> http://crynwr.com/~nelson
Crynwr supports Open Source(tm) Software| PGPok | There is good evidence
521 Pleasant Valley Rd. | +1 315 268 1925 voice | that freedom is the
Potsdam, NY 13676-3213 | +1 315 268 9201 FAX | cause of world peace.
--
Did you check the web site first?: http://www.crynwr.com/lego-robotics
|
|
Message is in Reply To:
 | | Re: Light outputs on RCX
|
| (...) I took apart a laser pointer. I put the laser module into a mutilated brick. I added a diode, an LM-317, appropriate resistors and a .1uF capacitor to make a 3 volt power supply. The diode makes it so the laser is on for motor forward, off for (...) (26 years ago, 18-Jan-99, to lugnet.robotics)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
