To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *756 (+5)
  RE: Modification of RC Servo motor
 
It varies slightly from servo to servo. Fundemmentally there is a potentiometer that measure the servo position and prevents mechanically the movement . You have to either remove it completely or take out the brush and mechanically (small screw (...) (30 years ago, 4-Sep-96, to lugnet.robotics.handyboard)
 
  Re: Charge polarity on each board opposite?
 
(...) Fred, I use dl on a DOS 286, which does the CONFIG register automatically I thought. In any case, I tried using dl -eeprom config0c.s19, with the same results. The dl of pcode_hb.lis runs nominally, but the LCD remains all black across the top (...) (30 years ago, 5-Sep-96, to lugnet.robotics.handyboard)
 
  Re: Charge polarity on each board opposite?
 
Hi Mike, I'm still out here. Let me know how I can be of assistance. - Prabal (...) (30 years ago, 5-Sep-96, to lugnet.robotics.handyboard)
 
  Re: Charge polarity on each board opposite?
 
(...) right; randy sargent's dl does automatically check the config and burn it if it's wrong. so your config is probably okay. (...) wait; you mean "pcode_hb.S19," right? when it downloads it doesn't give any errors? but the pcode still won't run. (...) (30 years ago, 5-Sep-96, to lugnet.robotics.handyboard)
 
  IR
 
How does one get the Sharp GP1U52 recievers to acknowledge the 100/125 hz scheme? I've tried using the set_ir_recieve_frequency and ir_counts routines but I only seem to be able to get recognition on port 15. Is there another piece of code that has (...) (30 years ago, 6-Sep-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR