 | | Re: RCX 2.0 -- ideas.
|
|
The Version @.0 should have a way to allow multiply RCX's to used. That way one RCX could be used for just the motor routines, one to handle sensors, one to do number chrunching, and etc. John A. Donaldson (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
|
| |
 | | Re: sensor input mux calculations
|
|
I've thought about this, but I've come up empty. If you could get between the input line and the 10K pull-up resistor, it would be easy. You could then wire the CdS cells on either side, with a 10K resistor from one cell to ground. Then when the (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Glueing blocks
|
|
I've successfully created mating surfaces by using a gel superglue. To create the mating surface, create a flat surface (if one doesn't exist) with epoxy. Then spread the gel glue on the suface, put down a piece of celophane wrap. Then press a lego (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
|
| |
 | | Re: voice recording and playback system
|
|
great website. Got a suggestion for you. Notice you are using the counter sink screws. Have looked at the brass #4 machine head screws? I am going to make some light sensors this weekend based on your design, for my project. I would think the (...) (28 years ago, 31-Dec-98, to lugnet.robotics)
|
| |
 | | Re: legOS - Does it work for you?
|
|
(...) If you change the BUTTON_RUN to BUTTON_PROGRAM in the speeds function it will work properly. Although there seems to be very little difference between a speed of 1 and a speed of 7. -rick (28 years ago, 31-Dec-98, to lugnet.robotics)
|