 | | RE: expansion board - servo control
|
| -----Original Message----- From: shsc9801@condor.stcl...dstate.edu [mailto:shsc9801@con...state.edu] Sent: Monday, December 21, 1998 1:39 PM To: handyboard@media.mit.edu Subject: expansion board - servo control Hi, I stopped working with the (...) (28 years ago, 21-Dec-98, to lugnet.robotics.handyboard)
| | |  | | expansion board - servo control
|
| Hi, I stopped working with the handyboard for a while but just started back up again. I put the expansion board onto my handyboard and began testing it. After testing the general tests done before with just the handyboard I started testing the servo (...) (28 years ago, 21-Dec-98, to lugnet.robotics.handyboard)
| | |  | | Re: RCX port information
|
| (...) I should clarify this before anyone breaks their RCX. The pins are 99% definitely unused. By the ROM driver. They might, however, be tied to Vss or Vdd, so make sure you don't short anything out if do attempt to solder something to the extra (...) (28 years ago, 21-Dec-98, to lugnet.robotics)
| | |  | | Re: flexible tubbing
|
| Linc Smith wrote in message ... (...) I went to the model store, and picked up small diameter silicon tubing used for fuel systems in RC models. To be honest I stopped looking after feeling the silicon tubing, so I didn't investigate the gum (...) (28 years ago, 21-Dec-98, to lugnet.robotics)
| | |  | | Fw: CdS Light Sensor
|
| Shame on me. I should have read the thread more carefully - my bad. trowt -----Original Message----- From: Barry Bott <barry.bott@virgin.net> To: lego-robotics@crynwr.com <lego-robotics@crynwr.com> Date: Monday, December 21, 1998 11:53 AM Subject: (...) (28 years ago, 21-Dec-98, to lugnet.robotics)
| |