To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6646 (-5)
  Re: stepper motors from 5 1/4 drives
 
Hi! (...) okay, another newbie reply :-) After I received this message I opened several 5 1/4 drives that were going to trash at my job and took all the stepper motors and integrated circuits. Here's what I figured out: 1 - All the stepper motors I (...) (28 years ago, 20-Dec-98, to lugnet.robotics.handyboard)
 
  Re: Vertical Mill
 
Robert Fay writes: > I have posted pictures and a QuickTime movie of my new vertical mill at > (URL) adding all of these to the ``Building'' section of the list web site at (URL) It would be great to know if the model is ``Mindstorms-Pure''. I'm (...) (28 years ago, 20-Dec-98, to lugnet.robotics)
 
  Re: All-around-the-robot bump detection
 
to Dennis Parker's point OK so you get this tube wired up to act as a switch. What's the energy drain on your batteries? What are the voltages required to exceed the limit value of the actuator? It sounds more accurate than an air filled tube (...) (28 years ago, 20-Dec-98, to lugnet.robotics)
 
  Re: a/d range
 
Hi friends! Thank you for the replies about this topic. Now I could get a Reference Manual too... The a/d range is determined by the references given to the VrefH and VrefL pins. But be careful about this: "There should be at least 2.5V between (...) (28 years ago, 20-Dec-98, to lugnet.robotics.handyboard)
 
  New robotics website online
 
Check out www.robotbuilders.com Add a link to your website in the Web Links section. Regards, Mark Williamson (28 years ago, 19-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR