To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6206 (-5)
  Re: effect of motor speeds
 
Humm... I think I switched the legends. Laurentino Martins (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  stepper motors from 5 1/4 drives
 
Okay, another newbie question: What do I need to take out of the 5 1/4 drive, other than the motor to get this to work? Also, what about drivers for the same? Anyplace I can get more info on this? I have a bunch of old drives laying around. thanks (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  Re: Stepper vs DC
 
(...) Actually, steppers do have some advantages. 1) If you do not have encoders on DC gearhead motors (or wheels, etc) they are notoriously hard to position accurately. Steppers can be controlled very accurately. Most servo motors cannot rotate (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  Re: effect of motor speeds
 
(...) I think it depends a lot on the weight of the robot and the type of mobility used. For instants, when I use tracks on my CyberMaster, 1 is very very slow and 7 is fast. All the other numbers between have speeds more or less according to this (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  Re: effect of motor speeds
 
(...) I think so, most problematical is the reduction in starting torque, free running always seems to peak at the same RPM. With an Acrobot based robot I have problems with wrinkles in the carpet stopping it when manoevering at low speed, but it (...) (28 years ago, 10-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR