 | | Re: Building gcc
|
|
Hello, Some time ago I tried to compile binutils 2.9.1 for H8/300 with cygwin on NT and I was also getting compilation errors. People from the binutils development team (Ian Lance Taylor, ian@cygnus.com and Kai Ruottu, karuottu@freenet.hut.fi) (...) (28 years ago, 20-Nov-98, to lugnet.robotics)
|
| |
 | | Re: One tip, and a few questions.
|
|
(...) 0-100. 100 being very very bright. (28 years ago, 20-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Sharp IS1U60 availablity
|
|
Check B. G. Micro 800-276-2206 www.bgmicro.com I would not be too concerned with the actual part number, just look for an Infared sensor or remote control sensor. Also get the pin outs as these may be different. Also have you considered using fewer (...) (28 years ago, 20-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: motor port problem .
|
|
Philip In a message dated 98-11-19 21:05:04 EST, you write: << hi, I have a big problem. I followed the method of yours that just lift up pin 8 of one L293 and wirewrapped it. The positive supply is wirewrapped to pin 8 . How about the negative (...) (28 years ago, 20-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | TEST
|
|
TEST (28 years ago, 20-Nov-98, to lugnet.robotics)
|
| |
 | | TEST
|
|
TEST (28 years ago, 20-Nov-98, to lugnet.robotics)
|
| |
 | | BrickCommand
|
|
Seems like everyone is writing software for the RCX these days. Well, I've written one for myself and figured I would put it on my website if anyone is interested. Check out: (URL) and go to the Lego section. It's a program editor/tester/debugger (...) (28 years ago, 20-Nov-98, to lugnet.robotics)
|
| |
 | | RE: BrickCommand
|
|
For some reason, the webpage loads slowly. Maybe Geocities or maybe my fault in bad webpage design, I don't know. If anyone knows why, let me know! Thanks again! (...) (28 years ago, 20-Nov-98, to lugnet.robotics)
|
| |
 | | Dark Grey Idler Gears (was Re: gear differential)
|
|
(...) teeth, (...) mechanically (...) FYI - the Technic Future Car (not to be confused with the Super Car) has three of the aforementioned idler gears, along with some other nice pieces, for about $44. Recommended. Regards, Issac. Knoxville, Tn (...) (28 years ago, 20-Nov-98, to lugnet.robotics)
|
| |
 | | RE: gear differential
|
|
(...) this is a fantastic device. i played with it today and build a new robot platform using it. i also flattened it by one layer, and i also make it one element wider (to make its width an even number, which makes it easier to work with). the main (...) (28 years ago, 20-Nov-98, to lugnet.robotics)
|