To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5211 (+5)
  Re: moving in a straight line with two motors?
 
(...) <snip> (...) Hey, sounds like goal right up there with the Mindstorms commercials - shoving all the plates off the dinner table, snapping pictures of women in the shower, etc. Great to see the big problems being solved on this list....:-> (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  Re: moving in a straight line with two motors?
 
(...) So _that's_ what they mean by a "pussy magnet"! (Sorry, sorry, I just couldn't resist). Cheers, Ben. (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  RE: moving in a straight line with two motors?
 
Uhh --- that was a stupid comment, wasn't it? How do the Lego guys guard (or shield) against the possibility of the motor magnets disrupting the electronics or memory onboard the RCX? Carl (with a very red, I-can't -believe-I'm-an-engineer, face) (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  Re: moving in a straight line with two motors?
 
Tim, Instead of using the differential for angle sensors, why not use it to allow a single motor to drive both wheels? Then a single angle sensor coupled with a motor could drive the steering mechanism. This setup would be very similar to a radio (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  Re: moving in a straight line with two motors?
 
(...) At one point, in the distant past, I saw plans for a gear box that used either 2 or 3 differentials, I do not remember which. 2 motors were used, 1 to drive both axles, one for steering. axle1 == motor1 + motor2 axle2 == motor1 - motor2 With (...) (28 years ago, 13-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR