 | | Re: Multiplexing Input Circuit
|
|
(...) The counter is a CMOS decade counter that has only one output high for each count. There is only one analog switch on at a time. The counter is reset when it hits the value 5 so it jumps back to 0 to start over. The analog switch is (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Tachocount
|
|
(...) I'm sure the motors may be used for other things as well, albeit not as easily as separate motors. (...) But in a program you will always know which way the motors drive, right? So one can possibly maintain a second variable for each motor (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Multiplexing Input Circuit
|
|
(...) The setup I was using was bi-directional too, I'm not sure exactly why I was seeing it, but I remember getting a high reading for a non-pressed touch sensor when the next one over (the previous one in the cycle?) was pressed. If I reversed the (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
|
| |
 | | Re: A spider (legged) RCX robot
|
|
(...) for moving the legs up and down very thoroughly, but not the rotating of the legs. The first time I saw the article, I thought the model moved by always keeping at least four legs fully extended. I later learned that this was not true, but I (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Tachocount
|
|
Do you think a tachometer needs to distinguish direction? Why? Going forward or not, a vehicle _moves_ from one place to the other, so the space moved must always be added, never subtracted. How could you otherwise figure _how_much_distance_ you (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
|