 | | Sensor inputs (more than three)
|
|
Has anyone noticed that each sensor input block has four connectors? If you connect one sensor to two connectors and another sensor to the other two, you essentially read both sensors simultaneously. If this could be munipulated somehow then you (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
|
| |
 | | Re: What about multiplexing sensors?
|
|
(...) I do. I only have two motors! 8^) But I'm looking at ways to use either the inputs to control the MUX or have an external control that the RCX can query to determine which sensor is currently active. ---Larry +---...---+ Larry Coffin (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
|
| |
 | | Re: What about multiplexing sensors?
|
|
(...) I guess I've lurked long enough...pardon my ignorance, but what's a MUX? --Andy (28 years ago, 11-Nov-98, to lugnet.robotics)
|
| |
 | | RE: Monitoring household power consumption
|
|
I purchased a power meter from Brand electronics. They have a few different models. There is one that is suitable for measuring the costs of one device and there is a larger one that has to be hardwired into your house. Check out (URL) are pretty (...) (28 years ago, 11-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: What about multiplexing sensors?
|
|
MUX is short for multiplexer. Just a switch that lets you hook multiple things to one input. (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
|
| |
 | | Re: What about multiplexing sensors?
|
|
(...) MUX is short for 'multiplexer' -- it is essentially a multi-switch device that switches a single input (or output) to multiple outputs (inputs). It would allow you to have 8 sensors (for example) connected to one input port and you could (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
|
| |
 | | Re: What about multiplexing sensors?
|
|
Okay...thanks. --Andy (28 years ago, 11-Nov-98, to lugnet.robotics)
|
| |
 | | Re: What about multiplexing sensors?
|
|
(...) Hang on - if you use all 3 outputs to control the MUX (which leaves me wondering why you'd bother - trees falling in forests and all that) you can get 24 inputs, even if you only treat each output as binary. More plausibly, you can use 2 (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
|
| |
 | | Re: RCX Programming Questions and Sensor Ideas
|
|
In article <199811102221.OAA071...ford.EDU>, Kekoa Proudfoot <kekoa@Graphics.Stanford.EDU> quotes and writes (...) You are right, of course. (...) If it does I haven't found it. (28 years ago, 11-Nov-98, to lugnet.robotics)
|
| |
 | | RE: What about multiplexing sensors?
|
|
You should be able to have three or more on/off sensors share a single input port without multiplexing. Just use a different resistor for each, so that any combination of pressing the three sensors yields a unique value out of 8 possible. For (...) (28 years ago, 11-Nov-98, to lugnet.robotics)
|