Subject:
|
Re: What about multiplexing sensors?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 11 Nov 1998 19:41:14 GMT
|
Original-From:
|
Larry Coffin <lcoffin@pointinfinity.&Spamless&com>
|
Viewed:
|
2831 times
|
| |
|
|
> 4. Some have proposed using a motor output to switch sensors, but its not
> like you have extra motor outputs to waste doing this.
I do. I only have two motors! 8^)
But I'm looking at ways to use either the inputs to control the MUX
or have an external control that the RCX can query to determine which
sensor is currently active.
---Larry
+-----------------------------------------------------------------------+
Larry Coffin lcoffin@PointInfinity.com
Point Infinity http://www.PointInfinity.com
Nantucket, Massachusetts 508-325-6677 * fax: 325-6676
+-----------------------------------------------------------------------+
Those who make peaceful revolution impossible will make violent
revolution inevitable.
-- John F. Kennedy
-
|
|
Message is in Reply To:
 | | What about multiplexing sensors?
|
| Has anyone attempted to mux the three sensor connections to expand the RCX's sensor capability? Think this is possible? I don't have an RCX of my own [yet] nor the EE capacity to pull this off, so I'm counting on the geniuses out there! --Steve (26 years ago, 11-Nov-98, to lugnet.robotics)
|
7 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
