 | | Re: Solar-powered RCX?
|
|
I think the RCX will use which ever supply voltage is greater. I havn't tested this, but I'll bet that when you plug the AC adapter into the RCX when the AC adapter is not even plugged into the wall the RCX will still work. This means there isn't a (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Firmware: IR transmission demystified
|
|
IR transmission was pretty tough to get at. Carrier frequency was the final key - there are no crystals to create the IR carrier, so the processor has to provide it. It turns out that 8-bit t1 output is used for just that purpose. Guess I'll have to (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Subtasks quitting before completing
|
|
(...) This weekend I built a 4x4 rover with two front bumper sensors. I was faced with the problem of both sensors triggering at the same time. My fix was to set the counter to 1 and add a stack controller to check the counter before turning the (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Subtasks quitting before completing
|
|
(...) The confusion is because only instantiation of each stack can be active at a time. If you start a stack that is already running, that stack stops, then restarts. The rule for conflicting signals is that the last one set has precedence. So if (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Spirit.ocx manual
|
|
Marshall Williams wrote in message <01BE0BB7.9F1AB180.M...tt.net>... (...) You may want to check out: (URL) Brok Visit LEGO ON MY MIND: (URL) section: (URL) (28 years ago, 9-Nov-98, to lugnet.robotics)
|