 | | charger board problems
|
|
I've managed to stick a wire onto a point in my battery pack which yields 6V. (temporary solution, at least...) However, the charger board doesn't seem to like this new arrangement much. With the lower battery voltage, too much current is flowing (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
| |
| | Re: charger board problems
|
|
(...) Or just use different motors. ;-) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
| |
| | Re: charger board problems
|
|
You could just get an adapter that is rated for a lower voltage. Try a nine volt adapter or a universal one that you can experiment with. -Fred -- This message was composed using Articulate Systems' PowerSecretary. Please forgive any sloppiness in (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
| |
| | Can't initialize CONFIG register
|
|
Hello, Everyone: Help! I'm trying to configure the HB. Here's what I get: C:\IC> dlm config0c.s19 -port COM2 -eeprom DLM: 6811 File Downloader... etc. Using COM2 Downloading to EEPROM Downloading config0c.s19, press ESC to abort Downloading eeprom (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
| |
| | NEW! - Handyboard Hard-to-Get Parts Kit!
|
|
CW Technology is now offering a kit of only the "hard to get" parts for the Handyboard 1.2. Basically, the kit includes everything you can't get at DigiKey and Mouser. The price is very competitive if you consider the minimum orders, shipping, etc. (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
|
