To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4556 (+5)
  Re: Extreme Creatures, Cybermasters, etc?
 
(...) Well, there are five yellow wheels on each side, and the tread goes round them. The wheels are probably as large as the medium pulley and one stud wide, with a narrow but deep groove in the center to keep the treads on track. The treads are (...) (28 years ago, 8-Oct-98, to lugnet.robotics)
 
  driving stepper motors
 
Hi all, I have nearly completed building my handy board and have come across a couple of stepper motors that i would like to use to drive my robot. Motor spec's are :- 2 Phase 6V 1.2A 1.8Deg step Is there any way of interfacing the handy board to (...) (28 years ago, 8-Oct-98, to lugnet.robotics.handyboard)
 
  Re: driving stepper motors
 
Look up the datasheet for the SGS-Thomson L297, they have a complete circuit diagram for a stepper motor driver there. (...) (28 years ago, 8-Oct-98, to lugnet.robotics.handyboard)
 
  Re: Extreme Creatures, Cybermasters, etc?
 
(...) ok, wasn't sure about that. (28 years ago, 8-Oct-98, to lugnet.robotics)
 
  Re: Extreme Creatures, Cybermasters, etc?
 
(...) But you could use the treads without, yeah? I'd really like some better treads, as the ones that come in Mindstorms RIS, Tread Trekker, and Mountain Rambler are too small for a lot of things. (Particularly, hard to power and still have a lot (...) (28 years ago, 8-Oct-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR