 | | Re: mindstorms NXT
|
|
(...) Here is a sample of the DEC RJ12 connector: (URL) like the same connection. -Rob A> (21 years ago, 8-Jan-06, to lugnet.robotics)
|
| |
 | | Re: new Mindstorms servos?
|
|
(...) The speed of the motor attached to another robot in the video shows that its speed is significantly slower than the 71427 motors supplied with the RCX 1.0 to 2.0. I suggest more like 60-100rpm rather than 300. This gives more torque for the (...) (21 years ago, 7-Jan-06, to lugnet.robotics, FTX)
|
| |
 | | Re: new Mindstorms servos?
|
|
(...) I spotted somewhere a mention of closed-loop controllers, which would mean that the motor *is* the rotation sensor. I expect the handle was installed to make it easier to manually adjust and test the mechanism and that the rotation sensing (...) (21 years ago, 7-Jan-06, to lugnet.robotics)
|
| |
 | | Re: new Mindstorms servos?
|
|
(...) From the picture, that is connected as an input, and the video posted by Yann shows this rotating under NXT control. It looks to me like it can be EITHER a rotation sensor or motor, but not both.... (21 years ago, 7-Jan-06, to lugnet.robotics)
|
| |
 | | Re: new newsgroup for NXT
|
|
(...) Lugnet in the past, IIRC, has created new newsgroups as soon as it was clear that there was a separate category, rather than waiting till close to or even after release. Thus, if I'm remembering correctly, there's precedent. (21 years ago, 7-Jan-06, to lugnet.robotics)
|
| |
 | | Re: new newsgroup for NXT
|
|
(...) How do you know? Perhaps topics discussed on one of those lists would have been of tremendous value to someone on one of the other lists - since that person didn't see the message, they'd never know that they'd suffered. It's hard to prove a (...) (21 years ago, 7-Jan-06, to lugnet.robotics)
|
| |
 | | Re: Mindstorms NXT programming languages
|
|
(...) A lot of people are saying this, but it's a bit off. The GameBoy had a Z80 based CPU; the GameBoy Advance has an ARM7. While the DS sports both, and uses the ARM7 to run GBA cartridges, a DS cartridge may well make use of both at the same (...) (21 years ago, 7-Jan-06, to lugnet.robotics)
|
| |
 | | Re: new Mindstorms servos?
|
|
(...) I'd say quite a bit of torque. It's possible they sacrificed some speed compared to the recent minimotors. Check out the tail of the "Sting" model, in the video clip at (URL). The rendered image of that model at (URL) shows quite clearly that (...) (21 years ago, 7-Jan-06, to lugnet.robotics, FTX)
|
| |
 | | Re: new Mindstorms servos?
|
|
(...) Dunno - I think it's *WAY* different. It's almost as if it were DESIGNED for making the robots that are in all the photos. It looks quite inconvenient for building wheeled or tracked vehicles because of how the drive shaft exits at right (...) (21 years ago, 7-Jan-06, to lugnet.robotics)
|
| |
 | | Re: mindstorms NXT and memory
|
|
(...) Actually, 64K of RAM is quite a bit. You have to remember that with the RCX you had 32K for everything. With the NXT all of the program code will go into (and run directly from) the 256K of flash -- this includes things that take up the most (...) (21 years ago, 7-Jan-06, to lugnet.robotics, FTX)
|