To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4361 (-10)
  Re: bootstrap mode in assembling the HB
 
yes, RP4 is four isolated resistors, and this being part of the serial line circuit, definitely explains your problem if you are using the common-terminal style. you can just install four 1K resistors if you don't have the correct r-pack handy. fred (...) (28 years ago, 9-Sep-98, to lugnet.robotics.handyboard)
 
  bootstrap mode in assembling the HB
 
hi At present I am up to section 4.4, "serial line and stop switch". I have installed all the components as per the section but when testing by applying power and holding down the stop switch, the HB will not go into bootstrap mode. I have not (...) (28 years ago, 9-Sep-98, to lugnet.robotics.handyboard)
 
  Fw: Current Rating use on HB
 
(...) that (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  encoder use in stepper motor
 
hi, How can i use my self build encoder to locate the position when my robot reach a position ? Is it suitable to use a self build encoder together with the stepper motor? The self build encoder consists a photoelectric reflector sensor mounted (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Re: IC dip 120 or Ic dip 210
 
(...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Current Rating use on HB
 
Hi, What is the current rating allow to be use on the HD if currently I am using a stepper motor of rating 4.5V and current 3Amp ? Is it all right directly plug it into the HB? How should I increase the acceptable current rating on the HB? How (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  IC dip 120 or Ic dip 210
 
Hi, Is there anybody came across such IC Dip 210 or Dip 120 ? rgds, chia (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  using interupts from IC
 
I want to drive 3 stepper motors form a handy board. I have the code running now as a dll under windows. What Im trying to gain from the HB is using interupts, so I can remain in connntact with the control while the steps time out- right now I just (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Re: Serial Communication with HP48 calculator
 
(...) not that i am aware of. you could connect to the HB's phone jack as long as you don't have to talk to interactive c and your calc at the same time. see the FAQ serial answer. (...) the SPI is for high speed SYNCHRONOUS comms (data and clock (...) (28 years ago, 7-Sep-98, to lugnet.robotics.handyboard)
 
  Bootstrap download mode
 
Hi I have been trying to get the HB into bootstrap mode without much success. Following the instructions in the manual, I held down the STOP button while turning on the HB. The red and green LEDs were supposed to turn on for a short period of time (...) (28 years ago, 5-Sep-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR