 | | Steppers
|
|
Hi. I was reading through a compilation of emails from the Handy Board Q&A and found a lot of great questions, but no answers to them. I am trying to power some steppers, microsteppers from the RobotStore catalog, with the HB and am not having much (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Serial line interrupt
|
|
(...) I had the same problem a few weeks ago, ended up writing an interrupt handler for the Handy Board which will buffer up the incoming serial information so that none of it is lost. I guess the Handy Board normally just polls the serial port (I (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | using the MC34064 LVI
|
|
Hello, This is a warning for anyone considering using the Motorola MC34064 to replace the DS1233. I have just built a couple handyboards and I had some problems getting them working. I finally tracked the problem done to the LVI. I used the MC34064 (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | Serial line interrupt
|
|
Hello all, I'm currently trying to communicate between the Handy Board and a PC (i486) using the existing serial line between the two. Sending data from the handy Board to the PC is no problem. An interrupt handler puts all incoming serial data into (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
| |
 | | Connecting radio module (BiM 418 F)
|
|
Hello all, I would like to be able to 'drive' my robot using the Handy Board via a radio link. For this purpose I have bought two transceivers, the Radiometrix BiM 418 F. How can I connect it to my Handy Board? The wiring is as follows (leaving out (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|