 | | Piggybacking sensors, but in a different way
|
| Is it possible to piggyback 1 sensor onto two rcx's? For instance, have one light sensor connected to port 1 of two different rcx's at the same time. The purpose would be for one rcx to control chassis movement, and another to control manipulator (...) (22 years ago, 26-Oct-04, to lugnet.robotics.rcx)
| | |  | | Re: Compound shaft
|
| (...) I've seen this done a) with a new style differential - it will spin free on a central axle and has a 24t gear at one end and a 16t at the other. b) two 16t "clutch" gears connected either via the toothed bearings, or via the driving ring (...) (22 years ago, 26-Oct-04, to lugnet.robotics)
| | |  | | Compound shaft
|
| Does anyone know of a compound shaft in Lego shafts? The primary purpose would be for a clock (minute and second hands) Thanks! Larry (22 years ago, 26-Oct-04, to lugnet.robotics)
| | |  | | Re: Mini-RCX
|
| (...) The pcb for my Brainibot kit is around that size. (Just search the web for "Brainibot".) It uses an 8-pin PIC and has two H-bridge motor drivers, two "antennae" (e.g. push switches), a light sensor and a sounder. One of the models is (...) (22 years ago, 26-Oct-04, to lugnet.robotics)
| | |  | | Re: Mini-RCX
|
| (...) Any idea on how I2C compares to 1-wire? I know that there 1-wire is being considered for some open-source home automation schemes because of the extremely low cost of interfacing, and the data rates seem comparable 115k for 1-wire vs. 100k for (...) (22 years ago, 26-Oct-04, to lugnet.robotics)
| |