To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3926 (+5)
  input impedance
 
Does anyone know the impedance onto the sensor inputs on the HB and/or any suggestions for setting them to receive signals sent at 220K Ohm. Joe Martin joema@mpx.com.au (28 years ago, 10-Jun-98, to lugnet.robotics.handyboard)
 
  Re: Windows NT experiences?
 
I use IC 2.8 under NT with no problems. Before you can use IC under NT, you`ll have to turn off the COM-port your HB is connected to under NT, or else NT won't let IC use it. You can delete the COM port in the `ports` part in you configuration (...) (28 years ago, 10-Jun-98, to lugnet.robotics.handyboard)
 
  Extra HB For Sale
 
I have one extra HandyBoard that I will sell if anyone needs one. It is a fully assembled and tested board with Serial Interface Board and cases. It has never been used in a project (about 2 months old). I built two of these and find that I am only (...) (28 years ago, 10-Jun-98, to lugnet.robotics.handyboard)
 
  (no subject)
 
--- Paul E. Rybski --- (URL) (28 years ago, 10-Jun-98, to lugnet.robotics.handyboard)
 
  Question about Sharp IR demodulators
 
Hi everyone, First, sorry for the blank message just now -- hit the send button instead of the cancel. I'm working on a project where I've got robots hunting targets equipped with a 40 kHz oscillator circuit which is continuously pulsing an IR LED. (...) (28 years ago, 10-Jun-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR