To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3856 (+10)
  Board not responding
 
Hi! The handy board was working good before and I haven't used the board for a while. Recently, I ran the downloader few times, but I couldn't download the bootstrap. I think the download mode is ready, but the error message like "Board not (...) (28 years ago, 23-May-98, to lugnet.robotics.handyboard)
 
  Re: Board not responding
 
(...) The most probable cause of this is a dead 6811. (it spoils rather easily... :(Because everytime i have a problem with the board, it turns out to be nothing more than a shot 6811. Even replacing the 7805 with a LM2931T kills it. (28 years ago, 23-May-98, to lugnet.robotics.handyboard)
 
  unsubscribe
 
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  unsubscribe
 
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  Pad sizes and hole sizes
 
I'm working on a board and I would like to avoid much trial and error. I have read much on selection of pad sizes/via sizes and hole sizes but there seems to be some contridiction. Does anyone know what the pad sizes (for ICs), hole sizes (for ICs) (...) (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  unsubscribe
 
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  Distance Measuring Sensor
 
Hi ! How is it possible to interface one or more SHARP GP2D02 to the HANDYBOARD ?? Best Rerards Diego (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  HOW TO UNSUBSCRIBE
 
Greetings, This is the periodic friendly reminder that in order to unsubscribe, you must send an email to fredm@media.mit.edu asking thusly. Again, the method for unsubscribing is: 1. write an email saying "please unsubscribe me"; 2. send it to (...) (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  Legos
 
Does anyone have any experience with any of the Lego technic systems. I am looking for a car/truck that has motors (or can add motors to), has enough room for a handyboard, and has the rack and pinion steering. I would also need a servo for the (...) (28 years ago, 25-May-98, to lugnet.robotics.handyboard)
 
  Pyroelectric Sensor
 
Hello. I have working with a handyboard, and I am trying to obtain information on how to properly use a eltec 442-3 pyroelectric sensor. I bought a complete one with a lens. My objective is for my lego robot to locate either a flame or heat source, (...) (28 years ago, 26-May-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR