 | | Re: maze solving algorithm
|
|
Timothy wrote in his posting (2003.06.01): (...) I dont know if i understand you right, but you should not put the ID into the cells but use all 16 bits of an array cell to store 4 maze cells in the way you propose. You can use SHIFT RIGHT operation (...) (23 years ago, 20-Jun-03, to lugnet.robotics)
|
| |
 | | Re: maze solving algorithm
|
|
(...) So you used the flood-fill or bellman algorithm described here: (URL) showed that URL in his posting at 2003 may 12). A synchro drive robot allways points in the same direction, so he could be controlled via PC by IR tower. I see problems (...) (23 years ago, 20-Jun-03, to lugnet.robotics)
|
| |
 | | Re: gear pulley/release system
|
|
(...) Thank you very much! (...) I don't see any reason why not to try it ;-) Off the top of my head, I can tell you that an RCX loaded with batteries is fairly heavy - maybe you'll need more springs and to pay carfeul attention to balance. Also, I (...) (23 years ago, 20-Jun-03, to lugnet.robotics, lugnet.technic)
|
| |
 | | Using sensor ports to send data
|
|
Hello, I did build an I2C device for the RCX a while ago, which is connected to the motor ports of the RCX. It now makes a speed of about 1.2kHz when using BrickOS (still thanks to Mark Riley for helping me whit this). But i think the sensor-ports (...) (23 years ago, 20-Jun-03, to lugnet.robotics)
|
| |
 | | Re: gear pulley/release system
|
|
Awesome... Just curious, what do you think about a Two Motor Jump-O-Bot using an RCX and 4 Large Springs? Think that would work? Rich (...) (URL) (...) (URL) you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. (URL) (23 years ago, 20-Jun-03, to lugnet.robotics)
|