 | | Re: DCC for the RCX
|
| In lugnet.robotics.rcx, Esger Abbink wrote: <snip> (...) Perfectly understood. Thanks! My problem has always been that I wanted to get into electronics, but all those resistors 'n such used to have all these coloured stipes to denote the different (...) (23 years ago, 30-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | |  | | Re: DCC for the RCX
|
| i have a question concerning how the DCC signal is sent Is it just sort of a "rider" on top of the power similar to X-10 home automation signals? If so could not the RCX be protected with diodes and used in conjunction with a standard train (...) (23 years ago, 30-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | |  | | Re: DCC for the RCX
|
| (...) put in (...) Thanks, Larry, and thanks to all who posted or emailed. (...) one (...) Or is (...) It's important that the motor outputs share the load as evenly as possible. A stalled train motor can draw as much as 750ma, while a single motor (...) (23 years ago, 30-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | |  | | Re: THOUGHTS on mapping with Lego Robot ( added to searching walls)
|
| (...) What about ultrasonic beacons at each corner of the room? Then use the old-fashioned Hyperfix calculations. It should cost only a few dollars in hardware - and six months of software development :-). Are they available off the shelf or are (...) (23 years ago, 30-May-03, to lugnet.robotics)
| | |  | | Communicating between two RCX'es with cable
|
| Hi there, Long time, no see - I've finally managed to dig out my Lego once again... First of all; I'm very pleased to see the outcome of LejOS 2.x - with Proximity, LLC, integration of rcxcomm, etc. Now, I was wondering if it would be possible (...) (23 years ago, 30-May-03, to lugnet.robotics.rcx.java)
| |