 | | Re: DCC for the RCX
|
| (...) output? Dave, I used a 1N4002. It's a fairly common 1 amp switching diode. Here's a picture from my latest decoder install: (URL) that the banded end of the diode gets the blue lead from the decoder. The unbanded end gets the white lead. If (...) (23 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | |  | | Re: THOUGHTS on mapping with Lego Robot ( added to searching walls)
|
| (...) Yes - but that is precisely 100% of the problem. There is no known convenient/cheap GPS-like system with the properties we desire. Camera's above the arena and things pasted onto the floor are not possible in many real-world situations. The (...) (23 years ago, 28-May-03, to lugnet.robotics)
| | |  | | Re: DCC for the RCX
|
| In lugnet.robotics.rcx, Mark Riley wrote: <snip> (...) Mucho appreciated Mark. The Diode--any diode will do? and just solder it across the connector output? Take care, Dave (23 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | |  | | Re: DCC for the RCX
|
| (...) I (...) resistors (...) goes (...) run (...) the (...) isn't (...) reduce the (...) David, When I installed my first decoders (Digitrax DN121), I omitted the capacitors, figuring if the buzzing was annoying, I could always add them later. As (...) (23 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | |  | | Re: THOUGHTS on mapping with Lego Robot ( added to searching walls)
|
| (...) items (...) the (...) (that (...) Even commercial guidence systems use periodic recalibration, for example with small magnets in the floor. The robot knows where the magnets are and if it finds a magnet off center to it's expected position it (...) (23 years ago, 28-May-03, to lugnet.robotics)
| |