 | | Re: Quick prototyping technologies
|
|
(...) I recently contacted Vero aboout Speedwire. The product is indeed discontinued and they have no old stock in the UK. However, speedwire pins are, apparently made for them by someone else. Unfortunately they could not find out (at that time) (...) (29 years ago, 1-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Schematic Question
|
|
You're missing the fact that the telephone style RJ-11 cable is an inverting cable. see page 11 of 16 of the Handyboard FAQ at (URL) a discussion and diagram of this (and the consequences of using the wrong cable!). -patrick ---...--- (...) (29 years ago, 1-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Schematic Question
|
|
I have been looking at the schematic for the handyboard and the RS232/Charger board. I noticed something that seems wrong. But how could it since this has been out for some time? Power goes out pin 4 of J10 on the Charger board and pin 4 on (...) (29 years ago, 30-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | V2x AND Polaroid Sonar
|
|
Hello again, Has anyone been able to wire the V2x compass and the Polaroid sonar device both to the HandyBoard and, if so, how was it done? Thanks, Scott sherman@plains.nodak.edu CSG ITS NDSU (29 years ago, 30-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | Quick prototyping technologies
|
|
I am looking for good methods for quick prototyping and would appreciate all suggestions. In Mobile Robots by Joseph L. Jones and Anita M Flynn, they suggest using Scotchflex by 3M and Speedwire by Bicc-Vero company as two good alternatives to using (...) (29 years ago, 30-Apr-98, to lugnet.robotics.handyboard)
|