 | | Re: make seems not to work
|
|
(...) Did you add the djgpp directory to your path? I don't remember everything I had to do, but here's a piece from MY autoexec.bat set path=c:\djgpp\bin;c:...til;%path% set djgpp=c:\djgpp\djgpp.env set shell=c:/djgpp/bin/sh.exe Steve (24 years ago, 12-Jan-03, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: I2C device for the RCX
|
|
(...) I think it will - as long as you put the sensor handler on timer B (the motor handler probably can stay there too). Take a close look at _ds_handler inside the file dsensor.c. That's where all the active/passive switching and sensor readout is (...) (24 years ago, 12-Jan-03, to lugnet.robotics)
|
| |
 | | Re: I2C device for the RCX
|
|
Hum. i think my first post was not very clear( and whit some stupid mistakes) I think you now how I2C works: there are to lines, SCL and SDA. so whit this device, I got to sensor ports, one for SCL and one for SDA. making high and low signals on the (...) (24 years ago, 12-Jan-03, to lugnet.robotics)
|
| |
 | | Re: I2C device for the RCX
|
|
(...) OK, stupid of me! (...) even more stupid..... Maybe I should go back to primary-school for a while to learn those things again (-: anyway, thanks for the suggestions. (24 years ago, 12-Jan-03, to lugnet.robotics)
|
| |
 | | Re: Received my RIS 2.0 - the two motors run at different speed! :-(((
|
|
(...) Once again, thanks for making all the calculations for me... Anyway, at the very least, I'll test all four of my other regular gear motors in a mindstorms robot. If I'm lucky to find a pair that are of equal speed, I'll use them in my (...) (24 years ago, 12-Jan-03, to lugnet.robotics)
|