To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *36129 (-5)
  Re: IR Tower not working when downloading firmware
 
(...) Which physical pins are 2 and 3? I assume they would be the Tx and Rx pins, but I don't know where they are. Pretty cool - data going through a paperclip. (24 years ago, 11-Jan-03, to lugnet.robotics)
 
  Re: IR Tower not working when downloading firmware
 
Andrew J. Huang wrote: > Wendy's problem is (...) The way to figure out which serial port on the back of the PC corresponds to which COM port is to use the world's cheapest piece of test equipment...the lowly paperclip. Bend your paperclip into a U (...) (24 years ago, 11-Jan-03, to lugnet.robotics)
 
  Re: Not really LEGO...
 
"Michael Obenland" <obenland@t-online.de> wrote in message news:H8I2sr.9Lz@lugnet.com... (...) Iain (24 years ago, 11-Jan-03, to lugnet.robotics)
 
  Re: Can't run software
 
(...) Thanks again Matthais, I have downloaded and installed this driver. But unfortunately there is no change. Bill Lane (24 years ago, 11-Jan-03, to lugnet.robotics.spybotics)
 
  Re: IR Tower not working when downloading firmware
 
No! Unless you need two RCXs - and that's a different question ;) Donwloading the firmware seems to be the most "stressful" exercise of the tower/RCX link. The download functions offered include a high speed mode and normal mode. The tower and RCX (...) (24 years ago, 10-Jan-03, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR