 | | Re: LMD18200
|
| Oh yeah, just use the regular motor IC routines. Plug and play! -=Scott Date sent: Wed, 8 Apr 1998 14:14:36 -0700 To: handyboard@media.mit.edu From: "Michael S. Reiling" <macman@inreach.com> Subject: LMD18200 (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
| | |  | | Re: LMD18200
|
| <FontFamily><param>Courier New</param>We've used the Wirz boards with great success here at Washington University. I can answer both of your questions at once, since they're the same thing. YES. Take the drivers off the handyboard, because now the (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
| | |  | | LMD18200
|
| I just bought the motor driver kit from wirz electronics, and I have finished putting it all together. My question is, do I take the motor drivers off of the HB and put them on the wirz board, or do I leave them on the HB. Question 2: Assuming I (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
| | |  | | Board Simulator
|
| Hi All, In the 3.1beta of the Mac version of IC was a board simulator. Is this still supported in the release version for the Mac? Will there be a port to the PC platforms? I find the simulator very helpful in a lot of situations. But since I do my (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
| | |  | | Re: SPI ram
|
| Anthony, A easier way to get 8K of EEPROM memory is to use Microchip Technology 25C640 Serial SPI EEPROM Memory. This is a 8 pin DIP device with a built in SPI interface. Cost is about $3 each. I wrote a simple application note to connect to a HB (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
| |