 | | Re: Firmware download troubles
|
|
(...) ... (...) Dick and others, Thanks - this helped. What I did to solve this was run the NCQ command-line download at "normal" speed. This worked the first time. Interestingly, I am not sure that the Bricx (v3.3) download was running quad speed (...) (23 years ago, 10-Dec-02, to lugnet.robotics.rcx)
|
| |
| | Re: Firmware download troubles
|
|
A likely explanation for your downloading problem is the following. Standard Lego software uses 2400 baud data rate and a protocol that sends "double" bytes. The "double" byte is that each data byte is followed by its complement. Alternative (...) (23 years ago, 10-Dec-02, to lugnet.robotics.rcx)
|
| |
| | Re: want to get inentors kit but...
|
|
(...) If you want to use the 'official' Lego software, then I'm not sure what Windoze OS's are supported - but certainly Linux isn't. However, many (most even?) serious users end up using a 3rd party software package called 'Not Quite C' (NQC) which (...) (23 years ago, 10-Dec-02, to lugnet.robotics)
|
| |
| | RE: Installation Help!
|
|
Max, Aha! I did that and it got a lot further this time, but still failed. I'll have to wade through the log file to try and pinpoint where it went wrong as I don't want to post the whole 180k. Thanks for your help! Andy -----Original Message----- (...) (23 years ago, 10-Dec-02, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Firmware download troubles
|
|
Matt, I discovered that the IR LED's and detector on my serial tower was located higher than I expected and pointed upward somewhat. I was able to get better transfers when the tower was leaning forward (pointing downward so to speak). Otherwise, I (...) (23 years ago, 9-Dec-02, to lugnet.robotics.rcx)
|
