 | | Re: Over Charging
|
|
Fred, We had the same problem and traced it to the resistor. We can try the ZAP mode, but for future reference we would like to know the value you used to replace the 47 Ohm 1/2 watt resistor. Any chance we could get that information? Thanks, Dan (...) (24 years ago, 11-Sep-02, to lugnet.robotics.handyboard)
|
| |
 | | Re: Questions about the first version of the control center console
|
|
(...) I think these are not original, so you will have to open the case to see where they end. This will tell you what you can safely do with them. Or if not, you can post another pic of the opened case ... Greetings Horst (24 years ago, 11-Sep-02, to lugnet.technic, lugnet.robotics)
|
| |
 | | Re: RCX to RCX
|
|
The answer very much depends on what you are using as a programming environment. The simple answer for NQC is Message(). I've used this very simple interface to do exactly what you describe needing. It is covered in NQC's accompanying documentation. (...) (24 years ago, 11-Sep-02, to lugnet.robotics)
|
| |
 | | RCX to RCX
|
|
I hope I am using this mailing system correctly. I am a first time user. I have one question to ask right now: Will someone point me in the right direction for instructions on RCX to RCX communication. I would like to encorporate 2 RCX bricks into (...) (24 years ago, 11-Sep-02, to lugnet.robotics)
|
| |
 | | Tutorial: use RCX motor output to switch devices / build your own interface
|
|
(...) I hope this tutorial will give you some good ideas of your own too! It can be found here: (URL) please e-mail me with your comments or mistakes in the tutorial, or post it here. Have fun, Remko (24 years ago, 11-Sep-02, to lugnet.robotics)
|