 | | RE: Programming multiple controllers
|
|
(...) OK, I'll bite, how does the Spybot get into this state? We've already discussed how to set up a secure link - how do we set up a non-secure link? Cheers, Ralph (24 years ago, 10-Aug-02, to lugnet.robotics.spybotics)
|
| |
 | | Re: Programming multiple controllers
|
|
(...) got (...) configuration? Bot one must be on Accept commands from ALL channels Mode. Dean (24 years ago, 10-Aug-02, to lugnet.robotics.spybotics)
|
| |
 | | Win98 install help
|
|
Hi there. Please can someone help me. I've been following the instructions at: (URL) word for word and then I got to the bit where it says: "Last setup I've tried let you choose which modules you need to download and setup. Here is a minimal list (...) (24 years ago, 10-Aug-02, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: measuring motor voltage on sensor input
|
|
Quoting Paul Andrews <paul@jools.net>: (...) How about a simple resistive divider across the motor output, say two 1 Kohm resistors, with the motor on the top of the two and the sensor input on the midpoint, so it sees the battery divided by two? (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|
| |
 | | RE: Brainstorms
|
|
(...) <just an opinion> The 2400 baud rate was probably chosen as a compromise between speed and what could reasonably be done on the teeny leetle PIC processor that drive the bricks. In practice, with the dedicated protocol that Wayne describes, (...) (24 years ago, 10-Aug-02, to lugnet.robotics)
|