 | | Smooth PWM routines
|
|
We are using the handyboard to control our mobile robot and wish to install the Skidmore smooth PWM routines as provided on the Handyboard web site. We are using Dunfield micro-C compiler version 3.1 in Windows95 along with the handyboard library (...) (29 years ago, 4-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | Config reg.
|
|
Using DL pcode_hb.s19 I got the following msg about 12 times, only on the 811e2 chips, the A1'a I could set the config to anything and change it back. Please place board in download mode and press RETURN To quit, press Q For help, press H (...) (29 years ago, 4-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: 9600 Baud / help with pa7
|
|
(...) Perhaps you have the RJ11 cable wired wrong. Make sure you have the ground signal and the data from pa7/digital 9 connected. see below... (...) Looking at the digital and analog sensor headers: live signal [ ] [ ] [ ] [ ] [ ] [ ] [ ] [ ] [ ] [ (...) (29 years ago, 5-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Connecting a second sonar module
|
|
(...) Sure, there's no reason you could set it up to use PD4, PD5, and TIC3 for a 2nd sonar. you might be able to get away with some signal multiplexing, assuming you're only firing one sonar at a time. i could see the BINH being no problem. For (...) (29 years ago, 5-Feb-98, to lugnet.robotics.handyboard)
|
| |
 | | Problems starting IC
|
|
I'm at the phase of bringing up a handyboard till a point where I have to start IC for the first time (chapter 6.0.5). I did succeed to download the PCODE_HB.S19 code and the board is starting with a beep and the IC startup message. So, that seems (...) (29 years ago, 5-Feb-98, to lugnet.robotics.handyboard)
|