 | | Re: Connecting radio module (BiM 418 F)
|
|
I have been thinking of getting a pair of those babies. How much did they cost you? Thanks. Jun Nolasco nolasco@inx.net (...) (29 years ago, 29-Jan-98, to lugnet.robotics.handyboard)
|
| |
 | | Congratulations (I think ????)
|
|
Hi Fred There was a short article on the news last night about a new Lego robotics product that looked alot like the "lego intelligent brick" concept you were working on last year... A bit of searching revealed the site (URL) which mentions the MIT (...) (29 years ago, 28-Jan-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Question re hc374 Digital Out Solution
|
|
Then if Y0, Y2, and Y4 were all used for this purpose, I assume 24 digital outputs could be realized? Cool. Thanks for the response, I'll give it a try. Stephen (...) (29 years ago, 28-Jan-98, to lugnet.robotics.handyboard)
|
| |
 | | Connecting radio module (BiM 418 F)
|
|
Hello all, I would like to be able to 'drive' my robot using the Handy Board via a radio link. For this purpose I have bought two transceivers, the Radiometrix BiM 418 F. How can I connect it to my Handy Board? The wiring is as follows (leaving out (...) (29 years ago, 28-Jan-98, to lugnet.robotics.handyboard)
|
| |
 | | Question re hc374 Digital Out Solution
|
|
I have already used the four digital outs on the SPI header and I need more digital outputs from my HandyBoard. These questions may show that I'm a neophyte as a hardware hacker, but I could use some help. In the HandyBoard FAQ under the question: (...) (29 years ago, 27-Jan-98, to lugnet.robotics.handyboard)
|